Filter
Top Products
VHF 100/200 Series Owner’s Manual 13
Basic Operation
Automatic Transmitter Identication System (ATIS)
ATIS is a vessel identication system that can be used on certain inland waterways in
certain countries throughout Europe. Your Garmin dealer can program your VHF 100i,
VHF 200i, or GHS 10i to use ATIS if you plan to use your radio on waterways that are
within the bounds of the Regional Arrangement Concerning the Radiotelephone Service
on Inland Waterways (the Basel Agreement). The use of ATIS is prohibited outside the
European inland waterways covered by the Basel Agreement.
When you enable ATIS, a data signal identifying your station is sent at the end of every
transmission. Data identifying your position is not sent; however, your position is calculated
through the method of triangulation by coastal stations receiving your transmissions.
To enable ATIS, enter your ATIS identication number (see below), and then turn on ATIS
(see page 14). Contact your Garmin dealer to determine your ATIS identication number
and to learn about ATIS requirements for your region.
Your radio disables the following functions when you enable ATIS:
Digital Selective Calling (DSC)
Dual watch and Tri watch
Channel scanning
The following International channels are restricted to transmit on low-power (1 watt) when
you enable ATIS: 6, 8, 10, 11, 12, 13, 14, 71, 72, 74, and 77.
Entering Your ATIS Identication Number
IMPORTANT: Use caution when entering your ATIS identication number because you can
only enter it once. If you need to change your ATIS identication number after entering it, you
must take the radio to your Garmin dealer for reprogramming.
1. Press the MENU key.
2. Select ATIS > MY ATIS ID.
3. For each number in the sequence, turn the Channel knob clockwise to increase the
number, and counterclockwise to decrease the number.
4. Press the Channel knob to accept the number and move to the next number in the
sequence.
5. Select ACCEPT when you have entered your ATIS number. The radio prompts you
reenter your number.
6. Enter your ATIS ID number again, and press ACCEPT. If the ATIS ID numbers you
entered do not match, the screen displays “ATIS ID NUMBERS DO NOT MATCH”.
Select RETRY and enter the numbers again.
•
•
•