Filter
Top Products
RPT 301 User Manual 25
K177 Issue No. 3
P - Change PIN
This command changes the PIN (Personal Identification Number) that
protects the calibration data. The instrument is shipped with the PIN
000. If the PIN is lost, the default (000) may be restored by fitting the
‘default’ link and switching off and then on.
Note: Restoring the defaults restores ALL of the factory settings including the
communication parameters.
Command: P, PIN, New PIN
Where: PIN is the existing 3-digit code (000 to 999) and New
PIN is the replacement PIN.
Reply: None
Result: PIN is replaced by New PIN