Filter
Top Products
Installation
6 306556S
Typical Installation
The Typical Installation (shown in fig 2) is only a guide
for selecting and installing this system. It is not an actual
system design. Contact your local Graco representative
for assistance in designing a system to suit your particu-
lar needs.
Positioning the Elevator
1. Position the elevator where the ceiling is at least 8 ft
(2.6 m) high. The elevator is 90 in (2.4 m) when fully
raised.
2. Provide adequate space in front of the elevator for
changing drums and in back and on the side for
plumbing.
Mounting the Elevator
1. Secure the elevator base (A) to the mounting base
(102) using screws (104), lockwashers (103), and
nuts (105). (Fig 3)
2. Bolt the mounting base (102) to the floor for stability.
3. Verify the elevator is level. Loosen on or two screws
(104) on the elevator base and place shims under
the base, if necessary.
4. Place the inductor plate (2, 18, or 22) on the mount-
ing base (102).
5. Loosen the screws (68) of both support brackets
(83). Slide the support (64) down far enough to
allow installation of the pump in the inductor plate.
Tighten the bracket screws lightly.
FIG. 2
mounting
holes
5’ (1524 mm)
supply lines
(through wall)
bleed-type
master air valve
high pressure
fluid shutoff valve
supply lines
(from ceiling)
3” (76 mm)
1” (25 mm)
6” (152.4 mm)
clearance
for plumbing
FIG. 3
A
102
103
104
105