Filter
Top Products
Page 4
SKU 92247 For technical questions, please call 1-800-444-3353
Additional Product Specific Safety Precautions
1. Before using, read all instruction and safety warnings provided in the instruction
manual provided with the Band Saw being used.
2. Verify that all Band Saw safety devices are installed correctly.
3. Verify that the saw blade is sharp and at proper tension.
4. Check that all saw blade guides are in place and properly adjusted.
5. Never leave the band saw unattended while running. Turn power off and wait until the
blade stops before adjusting the Saw Mill.
6. Before turning on the Band Saw, place the Saw Mill with attached log on the Band
Saw Table and make Fence depth adjustments. Verify that the log mounting screws
will not come into contact with the saw blade during a cut.
7. Before using the Saw Mill, make sure that all its assembly screws are tight.
8. This product is designed to be used only with Band Saws.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the following parts are included. Also refer to the
Parts List and Assembly drawing located at the end of this manual. If any parts are missing
or broken, please call Harbor Freight Tools at the number on the cover of this manual as
soon as possible.
Guide Slide with
Adjustment Plate (1)
Base Plate (2)
Slide Plate (4)
Handles (5)
Mounting Plate (6)
Acme Screw with Knob (8)
Back Plate (3)
Bushing (7)
Flathead Screw