Filter
Top Products
ASSEMBLY INSTRUCTIONS
I. The Plugs II. Traveler Assembly
The larger drain plug (part #25) is used to Figure 3 shows an example of a completed
drain the cockpit of the boat. Insert the large traveler line and block assembly. To assemble
t drain plug from the inside of the HOLDER@ 12 the traveler, first find the traveler block set.
into the drain hole, which is in the center and This block has two pulleys (part #24). Now find
bottom of the stern or rear of the boat (part the traveler line (part #19). Tie a figure 8 knot
. #29). Secure the plug by looping the line through in one end of the line and insert the other end
the padeye as shown in Figure 1. of the line', from the outside of the HOLDER@ ,
12, through the small hole in the upper right-
hand corner of the rear of the boat.
Fig. 1
The smaller plug threads into the hole located F. g 3
on the exterior of the transom by the large. 1 .
drain plug hole as shown in Figure.2. Be sure to Pull the l~ne all the way through and then
use the black gasket to prevent leaks. (This thread the lIne through t.he small block of the
may already be installed.) t:aveler block ~et: Now Insert the end of the
lIne from the InsIde of the boat through the
small hole at the upper left hand corner of the
boat. Tie a figure 8 knot in the end of the line.
Make sure the knots are secure and that the
traveler block set can run freely along the line.
.. Fig. 2
..
-4-