Filter
Top Products
• 10
Before installing the jib on
the Hobie Wave, you must
first install the parallel bow
spreader (provided with the
turbo kit). Install bow spreader
tangs on each bow under exis-
ting bridle wire tang as shown.
Pin faces towards center. With
trampoline loosened, place bow
spreader in position on pins ins-
talled on bows.
1
Before stepping the mast, Install jib halyard block on pig tail and place pigtail on the shroud shackle next to fo-
restay wire. Run the halyard through the halyard block and tie off ends at lower cleat. Install halyard shackle.
Step the mast.
Clip the jib tack to the spreader pole eye strap at center of the pole. Shackle the halyard to the jib head and
hoist. Tension lightly and cleat to lower cleat on the mast.
Tie one end of the jib sheet to the jib clew. Run the sheet to (inside the shroud wire) the swivel jam through the
dead eye first and then out jaws towards center of the boat. Pass the line behind the mast to the other swivel
cleat. Run the line through jaws first then dead eye. Run line forward (inside shroud) to the jib clew and tie off.
3
TURBO KIT
Install jib sheet swivel jam cleat as follows : unscrew the two screws of the
trampoline track, install the swivel jam cleat plate between the hull and the
track, screw again the two screws with washer to maintain the plate. Same
operation on the opposite hull.
2