Filter
Top Products
2
link of chain with marking pen for easy placement).
2. Lightly grease drum axle
Note: there are two methods of assembling the cables to the new drums -- on the
bench (3 through 7 "A" below) or with the drive properly mounted in a bench vise
(3 through 7 "B" below). Each is described separately. Use which ever is
easiest for you.
Bench method:
3 A. Mount left or right drum / crank arm assembly (noting correct side) onto
drum shaft
4 A. Install front and rear cable into upper drum slots as shown. It is easiest to
angle cable in from the side (below and right).
5A. Slip cables over top lip and hand
tighten new Nyloc nuts to keep cable
from slipping out (right).
6A. Insert idler cable into rear slot as
shown. Note -- this slot is divided -- use
outboard portion of slot (left).
7A. Flip drive over and repeat on other side.