Hobie V2 Drum Boating Equipment User Manual


  Open as PDF
of 4
 
3
Vise method:
3 B. Secure Drive to vise by rear
portion as shown. Use a rag in
vise to prevent marks (rag
removed for illustration purposes,
right).
4 B. Mount both drum / crank arm
assemblies to drum shaft, noting
correct left and right side.
5 B. Mount the rear sprocket cable. Note, the cable is first inserted from the
side, with the help of needle nose pliers if necessary, then re-routed over the top
lip of the drum. Hand thread Nyloc nuts enough to keep the cable from slipping
out (below).
6
B. Repeat procedure with the front sprocket cable.
7 B. Insert idler cable into lower rear
drum hole as shown. Note, the idler
slot is divided -- use the outboard
portion only (right).
 previous