Filter
Top Products
Attaching the Control Head to the Base
Follow these steps to attach the control head to the already-assembled base:
NOTE: Thetransducer cableandpowercable shouldbe routedpriorto securingthe
mounting bracket to the deck.
1. Apply marine-grade silicone sealant to the drilled holes for the
mounting bracket.
2. Place the mounting bracket on the mounting surface, aligning with the
drilled holes.
3. Insert the four #8 Phillips countersink wood screws into the mounting
holes and hand tighten only!
4. Insert the thumbknob bolt through the pivot knuckle on the control head
(Figure 7).
5. Align the pivot knuckle with the mount base arms and slide into place,
twisting slightly if necessary, until the unit is firmly seated.
6. Rotate the control head to the desired angle and hand tighten the
thumbknob bolt.
7. Thread the gimbal knob onto the pivot bolt and tighten.
Pivot Knuckle
Gimbal Knob
ThumbknobBolt
Figure7
Mounting Holes
6
Control HeadInstallation