Filter
Top Products
Attaching the Cables to the Control Head
Followthesestepstoattachthepowerandtransducercablestothecontrolhead:
1. Matching the cable plugs to the shape
and orientation of the sockets, insert the
transducer and power cables into the
correct sockets on the control head
(Figure 8).
2. With the control head in place, tilt
and/or swivel the unit through its full
range to make sure there is enough
cable slack for the unit to move freely.
Hand tighten the thumbknob bolt when
you achieve the desired position for the
control head.
You are now ready to install the transducer. See Transducer Installation
Overview and then find the section that refers to your transducer type.
Figure8
Power Temperature Transducer
7
Control HeadInstallation