Filter
Top Products
1. Assembling the PiranhaMAX™ Mount
YourPiranhaMAX™mountwilleitherhaveatiltmountoratiltandswivelmount.
Refer toeitherproceduresA or B belowto assemble themount.
A. If you have a tilt mount, refer to the following
information:
Noassemblyisrequiredforthetiltmount.Proceed
toAssembling the Base and Handle.
B. If you have a tilt and swivel mount, use the
following steps:
1. Insert the arms into the mount. Then, hold
the arms in place as you turn the mount
upside down.
2. Insert the swivel ring into the mount,with
the countersink holes for the arm screws
facingout.
3. Secure the arms with the 4 #6 screws
provided. Hand tighten only!
2. Assembling the Base and Handle
In this procedure, you will install the PiranhaMAX™ mount and handle to the
base oftheportable case.
1. Turn the base upside down.
Punch out the mounting holes
labeled“C”withahammerand
a screwdriver (or an awl) as
shown in the illustration
Punching Holes.
2. Turnthebaserightsideup.Line
up the PiranhaMAX™ mount
withtheholesyoupunchedout
instep1.
Tiltand Swivel
PiranhaMAX™ Mount
Arms
Mount
ArmScrews,
4#6 x7/16"
Countersink
SideOut
Swivel
Ring
Punching Holes
2