Filter
Top Products
Routing the Control Head Cables Under the Deck
Use the following steps to route the control head cables under the deck.
NOTE: Under thedeck cable routingis not alwayspossible. If this isnot an option,
the cables should berouted and secured above deck.
Tilt Mount or Tilt and Swivel Mount:
1a. Mark and drill a 3/4" hole as shown in
Figure 6. Route the cables through the
hole. The cables will exit through the
center hole on the control head base.
1b. If the cables cannot be routed directly
beneath the control head base, mark
and drill a 3/4" hole that will allow you
to run the cables close to the control
head base.
3
/
4
”
1
9
m
m
Figure6
Tilt Mountor Tiltand Swivel Mount
Control HeadBase
NOTE: See the installation section for your transducer type in order to plan the
location of the transducer and cableroute.
5
Control HeadInstallation