Humminbird 180 Fish Finder User Manual


 
Fish ID+
TM
(SetUp Menu)
(Setting Saved in Memory)
Makesure that the SetUp menuis selected, then pressthe POWER-MENUkey
untilFISH ID+
T
M
appears.Select eitherOff toview“raw”sonar returns or On to
view Fish symbols. Fish ID+
TM
uses advanced signal processing to interpret
sonarreturns,and will displaya Fish Symbolwhen very selective requirements
are met. A select number of possible fish returns will be displayed with their
associated depth. (On, Off, Default = On)
Scroll through all SetUp menu choices to exit the SetUp menu.
NOTE: Returns from the 200 kHz narrow beam are shown with shaded fish
symbols while the 83 kHz wide beam (and 455 kHz beam) returns are displayed
with hollow fish symbols.
NOTE: Hollow fish symbolsare not availableon 200 kHz Single Beamsonar units.
Bottom View (SetUp Menu)
(Setting Saved in Memory)
Make sure that the SetUp menu is selected, then press the POWER-MENU
key until BOTTOM VIEW appears. Bottom View selects the method used to
represent the bottom and structure on the display. (Structure ID, Black,
WhiteLine, Inverse, Default = Inverse)
Scroll through all SetUp menu choices to exit the SetUp menu.
RawSonar,
FishID+
T
M
Off
Single Beam
200kHz
Narrowbeam,
FishID+
TM
On
Dual Beam
Tri Beam
RawSonar,
FishID+
TM
Off
200kHz
Narrowbeam,
FishID+
TM
On
83kHz
Widebeam,
FishID+
TM
On
RawSonar,
FishID+
TM
Off
200kHz
Narrowbeam,
FishID+
TM
On
455kHz
Leftandrightbeam,
FishID+
TM
On
34