Humminbird 300 series Fish Finder User Manual


 
55
Noise Filter
(Advanced)
Noise Filter adjusts the sonar Noise Filter to limit interference on the display from
sources such as your boat engine, turbulence, or other sonar devices. The Noise Filter
menu choice is available when User Mode is set to Advanced (see Setup Menu Tab:
User Mode).
NOTE: The Off setting removes all filtering; Low, Medium and High settings add progressive
filtering of the sonar returns. In some deep water situations, the High setting may actually
hinder your unit’s ability to find the bottom.
To change the Noise Filter setting:
1. Make sure you are in Advanced User Mode, then highlight Noise Filter on the
Sonar main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Noise Filter
setting. (Off, Low, Medium, High1, High2, High3, Default = Low)
Max Depth
(Advanced)
Max Depth adjusts the maximum depth of operation. The performance of your 300
Series
TM
Fishing System can be tuned to the maximum depth you will be fishing in by
setting the Max Depth. When a maximum depth is set, your 300 Series
TM
Fishing System
will not attempt to acquire sonar data below that depth, thus increasing overall
performance. When Max Depth is set to Auto, the 300 Series
TM
Fishing System will
acquire bottom readings as needed (within the capacity of the unit). If the bottom is
deeper than the Max Depth setting, the digital depth readout will flash, indicating that
the 300 Series
TM
Fishing System cannot locate the bottom. The Max Depth menu choice
is available when User Mode is set to Advanced (see Setup Menu Tab: User Mode).
To change the Max Depth setting:
1. Make sure you are in Advanced User Mode, then highlight Max Depth on the
Sonar main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Max Depth
setting. (AUTO, 10 to 1000 feet, 3 to 330 meters [International Models only],
Default = AUTO)