Filter
Top Products
When the Wide Side transducer is connected directly to your unit, or selected using a transducer switch,
the unit setup must be changed to correspond with the type of transducer being used. This adjustment is
made through the "System Options" menu. Use the MENU button to select the "System Options" menu
and press ENTER. Press MENU until the "sonar mode" option is highlighted. Press UP or DOWN until
"side" is displayed. Press ENTER when the selection is correct.
Your Wide Vision is now configured for Wide Side operation.
When you exit the "System Options" menu, the view you will see on-screen is shown (above right).
Viewing both left and right sides simultaneously gives you an excellent tool when searching for bait fish or
following a creek bed, however greater display resolution can be achieved by viewing only one side.\
Experiment with the Wide Side transducer while operating it in a familiar area and learn how to make
maximum use of the information displayed. Remember, if you are using a trolling motor mount, the
information displayed is controlled by the direction the trolling motor is pointing, not necessarily the
direction the boat is travelling.