Filter
Top Products
32
4
BIIS OPERATION
4
31
4
BIIS OPERATION
■ Position data transmission
When the optional OPC-966
INTERFACE CABLE
and a GPS receiver
is connected to the transceiver, the position (longitude and latitude)
data can be transmitted automatically.
Ask your dealer or system operator for connection details.
The position data is transmitted when;
• Status 24 message is received
*When the status 24 message, GPS request, is received.
• Fully automatic
When automatic position transmission is enabled, send the po-
sition data according to ‘Time Marker’ and ‘Interval Timer’ set-
tings.
• PTT is released
When ‘Send with Logoff’ is enabled.
- Set the “Log-In/Off” item as “L-OFF”.
• After sending a status message
When ‘Send with Status’ is enabled.
• After sending an SDM
When ‘Send with SDM’ is enabled.
• After sending status 22 (Emergency)
When ‘Send with Emergency’ is enabled.
■ Printer connection
When the optional OPC-966
INTERFACE CABLE
is connected to the
transceiver, a printer can be connected to print out the received
SDM content and the ID of the station who sent the message.
Ask your dealer or system operator for connection details.
■ PC connection
When the optional OPC-966
INTERFACE CABLE
is connected to the
transceiver, a PC can be connected to provide remote control, data
reception, etc.
Ask your dealer or system operator for connection details.
■ Digital ANI
The own ID can be transmitted each time the PTT is pushed (log-in)
or released (log-off) during individual or group call communications.
By receiving the ANI, the communication log can be recorded when
using a PC dispatch application.
In addition, when using the ANI with log-in, the PTT side tone func-
tion can be used to inform you that the ID is sent and voice com-
munication can be performed.
!IC-F50_F60 BIIS.qxd 03.9.12 8:49 AM Page 31 (1,1)