Filter
Top Products
■ Error message list
*
1
Push any key to cancel the error message and beep tone. Turn the power OFF, then check the external data
cable connection.
*
2
An electricity failure may occur, turn the power OFF, then consult your dealer or service man.
*
3
Push any key to cancel the error message and beep tone.
*
4
Turn the power OFF, then check the system cable connections.
12
35
ERROR MESSAGE
Message Condition
BRG INPUT FAIL*
1
•The Azimuth signal is interrupted. An alarm tone is emitted within
5 sec. and the display reverts to H UP mode in approx. 1 min.
TRIG SIGNAL FAIL*
1
• If the TRIGGER signal is interrupted for more than 15 sec., an alarm
tone is emitted.
SHM SIGNAL FAIL*
2
• If the SHM signal is interrupted for more than 15 sec., an alarm tone is
emitted.
POSN INPUT FAIL*
1
• If the position signal is interrupted for more than 15 sec., an alarm tone
is emitted.
CHECK SCANNER CONNECTION*
4
•The system cable may not be connected properly.
MR-1000R2_T2.qxd 04.2.24 10:22 Page 35