Filter
Top Products
2 03530515_ed9
Product Description
This product is a non-regulating, pneumatically-operated, relay valve designed to provide control over uid ow to the starter motor in an air
starter-based, internal combustion engine starting system.
WARNING
General Product Safety Information
Read and understand this manual before operating this product.
It is your responsibility to make this safety information available to others that will operate this product.
Failure to observe the following warnings could result in injury.
Always install, operate, inspect and maintain this product in accordance with all applicable standards and regulations (local, state,
country, federal, etc.).
WARNING
Product Safety Information
This Starter Relay Valve is designed by Ingersoll Rand specically for use on Air Starter installations. Any other use may result in injury or
equipment damage.
Only use this Starter Relay Valve at or below 225 psig (15.5 bar/1550 kPa) maximum pressure, unless otherwise labeled. Higher pressure
may result in hazardous situations including rupture of the Starter Relay Valve and associated hardware.
To use this Starter Relay Valve at a pressure of 225 psig (15.5 bar/1550 kPa), all associated pipe, hose and ttings must be rated at 225 psig
or more. Some IR models are sold with lower pressure ratings due to associated piping.
Do not use this Starter Relay Valve with any corrosive gas or with any liquid.
Except for SRV100, SRV125, SRV150 and SRV150SS, the Starter Relay Valve was designed for use with compressed air only. Only those
models may be used with natural gas.
Always shut-o the air supply to the Starter Relay Valve, and bleed o any residual pressure, before performing any maintence on the
Starter Relay Valve.
Never remove the Retaining Ring from the Starter Relay Valve unless all pressure has been bled o. Internal parts will be forcefully ejected
if Retaining Ring is removed while pressurized.
Always wear eye protection when performing any maintenance on this Starter Relay Valve.
Do not remove any labels. Replace any damaged label.
Never use a damaged or malfunctioning Starter Relay Valve.
Do not modify the Starter Relay Valve.
Do not use this Starter Relay Valve for purposes other than those recommended.
Be sure all hoses & ttings are the correct size & are tightly secured.
Do not use damaged, frayed or deteriorated air hoses & ttings.
Safety Symbol Identication
DO NOT USE WITH
NATURAL GAS OR OTHER
FLAMMABLE GASES
Read Manuals Before Operating Product This warning applies to all Starter Relay Valves except SRV100,
SRV125, SRV150 and SRV150SS.
Safety Information - Explanation of Safety Signal Words
DANGER
Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
WARNING
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury or
property damage.
NOTICE
Indicates information or a company policy that relates directly or indirectly to the safety of personnel or
protection of property.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•