Filter
Top Products
4
If you are using the Tracker unit in Simulator when no transducer is con-
nected, any selected options are lost when the unit is powered off. The
Tracker unit will return to Factory Settings, or options selected when last
used with a transducer, if no transducer is connected.
IMPORTANT: A transducer must be connected to the Tracker unit
in order to retain user settings selected when in simulator mode.
If no transducer is detected, the unit defaults to pre-selected
options when powered off.
What You See On-Screen
Your Tracker unit uses a 128 V x 64 H
matrix FSTN LCD display. This display
provides outstanding viewability in all
light conditions over a wide range of
temperatures.
At initial power-up, the Tracker unit uses
settings that were set at the factory.
After initial use, the Tracker unit will
remember the settings you enter.
There are several elements on-screen
that are common to all modes of opera-
tion.
Temperature/Speed. The initial screen layout takes one of two basic forms
depending on whether the optional Temp/Speed accessory is installed. Figure
A shows the default view when the Temp/Speed accessory is installed. Figure B
shows the default view when the Temp/Speed accessory is not installed.
Depth. The digital depth number shows the water depth directly beneath the
transducer location.
Depth Range. The depth range is shown to the right of the screen. The upper
number is 0 indicating the surface of the water. The lower number is one of
the nine depth ranges available that best match the depth of the water. As the
USING THE TRACKER UNIT
WHAT YOU SEE ON-SCREEN
Figure A