Filter
Top Products
TS Series Conveyors Technical Manual 7610-002-98-29
Issued: 02-15-2006 Revised: N/A
SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS (CONTINUED)
20
CHEMICAL FEEDER EQUIPMENT: Detergent may be introduced into the unit through the
removal of the bulkhead plug in the rear of the tub and replacing it with the third party detergent
injection fitting. Remove the bulkhead plug in the side of the tub to install the detergent concen-
tration probe.
For more information concerning detergent concerns, please refer to the page entitled “Detergent
Control”.
The 1/8” brass plugs on the incoming plumbing rinse injector may be removed to install
rinse aid injection fittings.
All wires for the chemical injectors should be routed through
one of the extra openings in the back of the control box.
Terminals in the control box marked “CVS” provide a
constant voltage signal whenever the drive motor is
operating.
Terminals in the control box marked “DET” provide a
voltage signal whenever the wash motor is operating.
Detergent Connection Point
(Machine rear view)
Brass Plug
Brass Plug
Rinse Injector
Connection Points
Rear of Control Box