Filter
Top Products
28
■ Reverse
Your dealer may have programmed the Reverse
function instead of the Talk-Around function.
When using Reverse, the transmit and receive
frequencies are swapped. This means that you will
transmit on the “receive” frequency and receive on
the “transmit” frequency. The QT/DQT encoding and
decoding signals are also reversed, meaning that
transmitted signals are encoded using the “decode”
signal, and received signals are decoded using the
“encode” signal.
Toggle Reverse ON and OFF by pressing the key
programmed as Reverse.
• “R” or “RE” appears on the display while Reverse is
active.
■ Battery Voltage Level
While transmitting, the transceiver automatically
checks the battery voltage level. When the voltage
level becomes low, the LED indicator flashes red.
When a tone sounds, transmission stops. Recharge
or replace the battery pack at this time.
■ Lamp
Press the key programmed as Lamp to toggle the
display backlight ON or OFF. The backlight
automatically turns OFF approximately 5 seconds
after it is switched ON.
Press any key other than Lamp while the backlight is
ON to reset the 5 second timer. The timer will reset
and the backlight will remain on for 5 seconds.