Filter
Top Products
MT55F RAMMER — OPERATION AND PARTS MANUAL — REV. #5 (01/06/12) — PAGE 15
Inspection
1 . Check all nuts, bolts fasteners for tightness. Retighten as
necessary.
2. Clean any dirt from the recoil starter and foot pedestal. Wipe
the entire unit clean before operating.
3. Replace any missing or damaged Safety Operation decals.
4. Adjust height of handle. Adjust handle by loosening nuts and
moving handle to suit operation. Retighten nuts.
Figure 8. On Off Switch
Figure 7. Fuel Shut-Off Valve (ON)
2. Set the engine ON/OFF switch (Figure 8) to the "ON"
position (start).
3. Move the throttle lever to the "IDLE" position (Figure 9).
edarGliOrotoM3elbaT
erutarepmeTronosaeS
liorotomfoedarG
)ssalcSMnahtrehgih(
nmutuAroremmuS,gnirpS
F°51+otF°021+
03EAS
retniW
F°5
1+otF°04+
03EAS
F°51+woleB03-W01EAS
Figure 6. Engine Oil Dipstick (Oil Level)
Initial Start-up
When starting the MT55F Tamping Rammer perform the
following:
1. Open the
fuel shut- off valve
by moving the
fuel cock
lever to the
open
position (Figure 7).
OPERATION