Filter
Top Products
4-45
Controls and Indicators
Automatic Bilge Panel (standard with keyless ignition)
Bilge Pump Only Mode - This feature is activated by a switch located
on the side console. The switch has three positions, ON, OFF and
BILGE. If the boat is going to sit for more than a few days with the
bilge pumps on, it is important the switch is set in the BILGE
position to minimize battery drain. This will activate the bilge pump
and shut off power to the Serial Switching and Keyless Ignition
System. It is important to remember the engine or other accessories
can not be used unless the switch is in the ON position.
A circuit breaker and indicator light is located with the switch for
the bilge pump. The circuit breaker is only active when the switch
is in the BILGE position. The indicator light will come on anytime
the bilge pump is activated.
Battery Disconnect Switch (optional)
The battery disconnect switch allows you to isolate all power to the
boat. This switch provides positive disconnect of the battery to
protect against tampering, electrical fire hazards and battery
rundown. Rotate the switch to the OFF position when the boat in
not in use.
W
A
T
E
R
E
E
1/2
1/2
F
F
W
A
T
ER
CORC049
Nautique Ski Sec 4.qxd:Nautique Ski Sec 4.qxd 6/19/07 4:44 AM Page 45