Filter
Top Products
26
Selecting Automatic Answer Delay
You can select how many seconds the
ringer rings before automatically
answering calls when using the headset.
This program is displayed only when
“Setting the Automatic Answer Mode” is
set to “INT/CO” or “INT ONLY”.
(default: 6 seconds)
NOTE:
• If you set “INT/CO” or “INT ONLY” to the Automatic
Answer Mode (PS programming) and connect the
headset, your phone will answer incoming calls
automatically. If you leave your PS unattended with the
headset connected, the following problems will occur.
1.The PS will answer calls and the calling party will be
charged even though you are not there to take the call.
2.Even if the calling party disconnects the call, the
DECT line will remain connected until you disconnect
the call manually or the battery expires. This occurs
depending on the line. The PBX trunk may also
remain connected to the network. Please note the
following;
a) Please set “INT/CO” or “INT ONLY” to the
Automatic Answer Mode only when necessary.
b) If you are using the “INT/CO” or “INT ONLY”
setting in the Automatic Answer Mode and you take
off the headset, pull the headset jack out.
PS PROGRAMMING (CONT.)
AUTO ANS DELAY
6s
CHANGE=SELECT
Display example
TD7590-E(25~36) 00.8.11 5:06 PM Page 26