Filter
Top Products
C1445M-D (11/04) 7
Pressure Sensor Installation
To install the pressure sensor, perform the following steps.
1. Remove the screw located inside the top portion of the enclosure’s rear plate (refer to Figure 2). Insert the pressure sensor tube fitting in the
hole.
2. Loosen the camera sled mounting screws (refer to Figure 2). Slide the sensor bracket under the mounting screws and ground lug. Tighten
the screws.
3. Connect the wire leads (refer to Figure 2 and Figure 3):
a. Green/white wire - Insert the push-on lug into the connector on the pressure sensor assembly. Connect the spade lug to the power
terminal block under the AC NEUT wire.
b. White/green wire - Insert the push-on lug into the connector on the pressure sensor assembly. Connect the spade lug to the power
terminal block above the AC LINE wire.
Figure 2.
EH8100 Series Enclosure - Rear Plate, Inside View
GROUND STUD
REMOVE
SCREW
INSERT TUBE
FITTING
WHITE/GREEN
WIRE
GREEN/WHITE
WIRE
SLIDE SENSOR BRACKET
UNDER MOUNTING SCREWS
AND GROUND STUD
CAMERA SLED