Filter
Top Products
MAINTENANCE
Storage conditions.
*
Temperature: -20 to +60°C
*
Humidity: less than 85% relative humidity.
*
Do not store the instrument in places where:
1 - There is a high degree of humidity.
2 - The instrument is exposed to direct sunlight.
3 - The instrument is exposed to a source of high temperature.
4 - There are strong vibrations.
5 - There is steam, salt and/or corrosive gas.
The instrument body is made of plastic so it must not be cleaned with sol-
vents which can spoil plastic.
SERIAL OUTPUT
To enable the serial output of the instrument proceed as follows:
1. Insert the SUB D female 9-pole connector of the adapter cable with elec-
tronics AD RS232C in the DIN 9-pole socket on the instrument.
2. Connect the SUB D female 25-pole connector of the fitting to the serial
input of the printer or computer. The position of the switch in the connec-
tor must be:
DCE: data communication equipment (Modem)
DTE: data terminal equipment (Computer)
3. If you want to send what is shown on the display (once only), press the
key until the instrument emits two beeps.
4. If you want to send what is shown on the display continuously, at a fixed
rate of once every 10 seconds, press the key until the instrument
emits three beeps.
5. To disable the serial output in continuous transmission, press the key
until the instrument does not emit a beep.
6. If the serial output is not being used it is advisable not to fit the cable
AD RS232C on the instrument, thus saving battery consumption.
7. Serial output: RS232C
Data transmission speed
300 baud
8 data bit length
1 start bit
1 stop bit
no parity
ENGLISH
– 34 –