Filter
Top Products
Using Your CB
9
After calibration, the current compass heading displays. For
example, if the compass heading is south, the south
cardinal point appears. Or, if the compass heading is
northeast-north, the northeast cardinal point appears and
the north cardinal point flashes.
75+0)"/'/14;
You can store three channels in the memory. The preset
channel stored in
MEM1
,
MEM2
, and
MEM3
is Channel 1.
Press the memory location number to switch to the stored
channel. The channel number,
C;C
C;CC;C
C;C
and the memory
location number appear.
1. Select the desired channel.
2. Briefly hold down the desired memory location button.
C;C
C;CC;C
C;C
and the memory location number flash twice.
75+0)".#56"%*#00'."4'%#.."*4%.+
In CB or monitor mode, press
RCL
to return to the last
channel used for more than 3 seconds. Press
RCL
again to
return to the previous channel.
#&,756+0)"6*'"$#%-.+)*6
You can adjust the backlight by rotating
DIMMER
. To turn off
the backlight, rotate
DIMMER
fully counterclockwise.
64#05/+55+10"%1746'5;
Follow these guidelines for radio courtesy when using your
CB.
• Wait for a pause in someone else’s transmission before
you ask for a break.
• If you do not receive an answer to your call after a
second attempt, sign off and wait several minutes
before trying again.
• Do not hold down
PUSH
TO
TALK
when you are not
talking. (This is called dead keying.)
• Assist callers with directions, information about road
conditions, and any other reasonable requests.
±
"016'"
±
"
• When you rotate the channel
selector or press UP or DOWN
on the microphone to turn to the
channel stored in the memory,
C;C
C;CC;C
C;C and the memory location
number appear.
• The channel will only be saved
to RCL memory when the
current channel is manually
turned using the rotary switch or
UP or DOWN on the
microphone and stays on the
channel for more than 3
seconds.
• You cannot recall an emergency
channel or a memory channel
by pressing RCL.