Filter
Top Products
11
To silence the alert tones, press ALERT TONE OFF.
WX/ALERT flashes until you switch to WX mode and listen to
the broadcast. Or press
PTT to silence the alert tones so
WX/ALERT stops flashing. Ô
To reduce the alert tone levels for subsequent alerts, hold
down
ALERT TONE OFF for about two seconds while
WX/ALERT flashes. The tone stops and WX/ALERT flashes
slowly. If the radio receives a new weather alert, three
low-level, short beeps sound (regardless of alert type).
To listen to the weather when an alert is received, slide
CB/WX to WX. WX/ALERT turns off.
USING DUAL WATCH
You can set your radio to constantly monitor for emergency
(Channel 9) signals. If an emergency signal is received, the
CB radio automatically tunes to Channel 9 so you can hear
the broadcast. When finished, the radio returns to the
previous station. This feature only works in CB mode.
To activate dual watch, press
DUAL WATCH. DUAL WATCH
lights. Press
DUAL WATCH again to deactivate.
REPLACING THE FUSE
The CB’s in-line fuse protects it from power surges and
short circuits. When replacement is required, use a 2-amp,
fast-acting glass fuse, available at your local RadioShack
store.
1. Make sure the vehicle and CB are turned off.
2. Hold the fuse holder at both ends, push the ends
together, twist one end counterclockwise, and pull them
apart.
3. Remove the old fuse and inspect its condition. If it is
blown, insert a new one of the same type and rating. If
it is not blown, reinsert it.
4. Push the fuse holder ends together and twist one end
clockwise.
Ô NOTE Ô
You cannot transmit while
WX/ALERT flashes in CB mode.
Fuse
Fuse Holders
CAUTION
Do not use a fuse with ratings
other than those specified here.
Doing so will make your CB
susceptible to electrical damage.