Filter
Top Products
4 Linear Rudder Position Sensor
Mounting
1. Use the steering system to position the bullhorn ram amidships.
2. If necessary, release the hydraulic pressure from the boat’s
hydraulic steering system
Note: Contact your steering gear manufacture for advice on this step,
and follow their instructions for releasing the hydraulic pressure.
3. Loosen the starboard bolt that secures the bullhorn ram’s shaft to
the end bracket.
4. Fit the U-bracket (supplied) over the end bracket and the bullhorn
ram’s shaft.
5. Hand tighten the starboard bolt to hold the U-bracket in place.
6. Fully open the hose clamps (supplied) using a flat bladed
screwdriver, then hang them over the bullhorn ram.
7. Place the spacers (supplied) on the bullhorn ram and use adhesive
tape to secure them temporarily.
8. Pull out the rudder sensor’s shaft until its alignment mark is level
with the end of the barrel.
9. Position the rudder sensor against the spacers so the threaded rod
end of its shaft passes through the U-bracket.
D5390-1
End
bracket
Cable
Bullhorn
ram
Spacer
Sensor
barrel
Hose clamp
Alignment mark
Sensor
shaft
U-bracket
Nut and
washer
Bullhorn
ram shaft
Starboard
bolt
Threaded
rod
Sensor
shaft
Sensor
barrel
81006_3.book Page 4 Tuesday, May 22, 2001 1:03 PM