Filter
Top Products
Troubleshooting
Problem Possible Solution
PDP set is turned on and the
message “No Wireless Signal or
Please Check WIRELESS HOME
AV CENTER Power” appears.
Cause 1: The WIRELESS HOME
AV CENTER is turned off.
Cause 2: The message still appears
despite the AV Center is on.
The picture continuously breaks
up and the message “No Wireless
Signal or Please Check WIRELESS
HOME AV CENTER Power”
appears.
Cause: The product utilizes 5GHz
band for wireless signal transmission.
Other wireless devices may cause
picture noise or communication
errors. These problems may be
caused by Wireless PC networks
or wireless TV sets using the same
band.
The message “Please check
resolution, AV Center can’t support
720p/1080i component signal.”
appears in the Component Mode.
Cause: AV Center only handles of
480i and 480p input. 720p and 1080i
input cannot be processed.
There is no signal in a digital
channel, and messages “Searching
for Signals” followed by “No Signal”
appear.
Cause: Channels have been stored
using Auto Memorize but the
broadcasting companies are not
sending the corresponding signals.
Or External Input has been selected
but there is no signal.
Solution 1: Turn on the PDP set and then turn on the AV Center as they have
separate power supplies.
Solution 2: Check if AV Receiver’s LED at the top of PDP set and the AV
Center’s wireless LED are ON and green.
If both are OFF, change both devices’ positions so that they face each other for
better communication. If the message appears again, turn both PDP and AV
Center OFF and then turn them back ON. If the problem persists, contact the
nearest service center.
Solution: During watching, another wireless device that uses a single fixed
frequency of the same band may interfere and cause this problem. In this case,
turn the PDP and AV Center off and then back on. The WIRELESS HOME AV
CENTER has the function of frequency search in the 5GHz band for clear data
communication to avoid signal interference.
Solution: Switch the input source to 480i or 480p.
Solution: Select an alternative channel or switch the external input source.
PDP (Continued)
11
BN68-00766B-00Eng_1013 10/13/04 11:13 AM Page 11