Filter
Top Products
Rudder Stock
One rudder stock is supplied with the boat and can be taken on and off the boat by removing the top safety pin
through the gudgeon pintle. The rudder stock also comes with a tiller extension that can be added or removed easily
by snapping together the two parts at the base of the tiller extension universal joint. For fastening the rudder into the
stock there is a 6mm bolt with two wing nuts on each side and also a plastic pin for locking the rudder down. The bolt
goes in the top locating hole and the plastic pin goes in the lower hole.
Covers
The boat comes with a bottom cover and top cover for the hull and the centerboard and rudder will be inside the foil
covers. The top cover can be used with the mast rigged or with the mast down.
Trolley
The trolley supplied will come with all fasteners plus one fastening key, it will be disassembled. For assembly
instructions see the instructions supplied with the trolley. The assembled trolley should look like the picture below.