Filter
Top Products
Permanent Installation
Figure 3, Wiring the STP-1000T power inverter
Caution: Always use adequate wire size and fusing for any installation
Wiring Steps
• Disconnect the positive battery terminal before doing any wiring to the inverter.
• Using proper sized copper wire and proper terminations, wire the inverter to the electrical
system and fuse block. See your local RV dealer or automotive shop for wire, connectors, fuse
block and other wiring parts. Tighten all connections firmly, but do not over tighten.
Remember to recheck all connections every few months of operation.
WARNING
Do not operate the power inverter without a fuse installed.
page 8