Sony SSM-175A Marine Instruments User Manual


 
3
English
For the customers in the U.S.A.
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
For the customers in Canada
The Class A digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
CAUTION:
These potential hazards shall be considered common to
most rack installation.
1) Elevated Operating Ambient Temperature
After installed, the operating temperature may be greater
than room ambient. Consideration shall be given to the
environment temperature compatible within the
Manufacturer’s specified limit of Ambient Temperature of
0°C – +35°C.
2) Reduced Air Flow
After installed, the amount of air flow required for safe
operation of this equipment shall not compromised.
3) Circuit Overloading
Before installing, refer to rated current on this equipment
and make sure that no overloading to the supply circuit
on the rack.
Please confirm the rated current described on this
Operating Instructions.
4) Providing Protective Earth
When this product is installed in a rack and supplied
power from an outlet on the rack, please confirm that the
outlet is provided with a reliable protective earth
connection.
5) Prevention against achieving hazardous condition
due to uneven mechanical loading
When this product is in a rack, please make sure that the
rack does not achieve hazardous condition due to
uneven mechanical loading.