Filter
Top Products
FF520 Page 39
7. TIPS OF OPERATIONS
7.0 HOW CAN I DISCONNECT THE CABLES FROM THE FF520 IN
CASE I NEED TO DO SO FOR THE INSTALLATION?
· Open the FF520 box by unscrewing the four screws (see the following figure).
Figure 7.0 - The FF520 (I)
· Once the screws are removed, pull out the panel and the Printed Circuit Board (PCB).
Unscrew the cables from the PCB.
Figure 7.0a - The FF520 (II)
· Wire the cables as needed.
· Reconnect the cables to the PCB (see the Figure 5.1 for reference).
· Push the panel towards the case (be sure to have well positioned the rubber gasket).
Close the FF520 box by screwing the four screws.