Filter
Top Products
Owner's Manual
GX1250SPage 10
4.3 INSTALLATION USING REGULAR MOUNTING
BRACKET
1. Mount the bracket using the washers, nuts, and long hex head bolts.
2. Thread the mylar washers onto the mounting bracket knobs.
3. Position the transceiver within the bracket arms, matching the
transceiver notches to obtain the desired positioning.
4. Secure the transceiver to the brackets with the mounting knobs (see
Figure 4).
5. Connect the antenna and power cables (and optional speaker) to the
transceiver.
4.4 INSTALLATION USING CMB16 FLUSH MOUNT
BRACKET (Optional)
Refer to Figure 5 for the following procedure.
1. Use the template supplied with the CMB16 to mark the location
(inner template) where the rectangular hole (5-5/16 by 2-1/16 inches)
is to be made. Confirm the space behind the dash or panel is deep
enough to accommodate the transceiver. There should be at least
1/2 inch between the transceiver’s heatsink (fins) and any wiring,
cables or structures.
2. Cut out the rectangular hole and insert the transceiver.
3. Fasten the brackets to the sides of the transceiver with the lock
washer nut combination, so the mounting screw base faces the
mounting surface (see Figure 5).
4. Turn the adjusting screws to adjust the tension so the transceiver is
against the mounting surface.