Filter
Top Products
page 16 Owner’s Manual HX260S
4.14 OPERATING ON CHANNEL 67
When channel 67 is used for navigational bridge-to-bridge traffic between
ships, high power may be used temporarily in the USA mode by pressing
the H/L key before transmitting. When the PTT switch is released, the
transceiver will revert to low power.
4.15 RESETTING THE TRANSCEIVER’S
MICROPROCESSOR
Resetting the microprocessor restores the initial, factory supplied
conditions in the transceiver. These are called the default conditions. To
reset the microprocessor, first turn the transceiver off. Then while pressing
and holding the WX and SCAN keys, turn the transceiver on. The default
conditions are:
• No channel numbers are in SCAN memory.
• Channel 16 will be selected when the transceiver is turned on.
• WX channel 01 will be recalled when the WX key is pressed.