Filter
Top Products
page 6 Owner’s Manual HX260S
t SCAN KEY
Memory SCAN
1. Press once to start or stop scanning programmed channels.
NOTE
This function will not work if the radio is scanning.
Secondary use
1. Press and hold to store the selected channel into the transceiver’s
scan memory for scanning. Press and hold down the SCAN key again
to store or delete a channel from the scan memory.
2. Holding down the SCAN and WX key while turning the power on,
resets the microprocessor and erases scan channels from memory.
This clears the memory and establishes the factory-set defaults. For a
list of these defaults, see the section on resetting the Transceiver’s
Microprocessor.
y H/L KEY
Toggles between high (5 watts) and low (1 watt) transmit output power.
Does not operate on “low power only” and transmission-inhibit channels.
When this key is pressed while the transceiver is on channel 13 or 67, the
power will temporarily go high when the PTT switch is pressed. When the
PTT switch is released the power setting reverts to low.
u WX KEY
Immediately recalls last selected weather channel.
Secondary use
1. Holding down the 16/9 key while pressing the WX key, changes the
mode from USA to International or Canadian.
2. Holding down the WX and SCAN key while turning the power on,
resets the microprocessor and erases scan channels from memory.
This clears the memory and establishes the factory-set defaults. For a
list of these defaults, see the section on resetting the Transceiver’s
Microprocessor.