Filter
Top Products
HX270SPage 26
TROUBLESHOOTING CHART
6. MAINTENANCE
To receive warranty service, the purchaser must deliver the Product, trans-
portation and insurance prepaid, to STANDARD HORIZON Marine Repair
Department (a division of VERTEX STANDARD), 10900 Walker Street Cy-
press, CA 90630. Include proof of purchase indicating model. serial num-
ber, and date of purchase. STANDARD HORIZON will return the Product to
the purchaser freight prepaid. For general troubleshooting, refer to this
Troubleshooting Chart.
SYMPTOM
The SCAN key
does not start the
scan.
The USA/INTL/
CAN modes do not
function.
Press and holding
the SQL key does
not eliminate back-
ground noise.
Cannot change
any function.
Key Lock does not
function.
Indicator does not
light when charg-
ing a battery.
PROBABLE
CAUSE
No channels
memorized.
Squelch is not ad-
justed.
Proper operation
not followed.
Low battery.
Key Lock is on.
Proper operation
not followed.
Defective battery
FNB-83 or cor-
roded contacts on
battery or charger.
REMEDY
Use the MEM key to enter
desired channels into the
transceiver’s memory.
Adjust the squelch to thresh-
old or to the point where noise
just disappears. Further ad-
justment of the squelch con-
trol may eliminate incoming
signals.
HOLD down the 16/9 key and
press the WX key.
Charge battery. Refer to sec-
tion 3 of this manual.
Turn Key Lock off. Refer to
section 4.1. .
Hold down the H/L key for 1
second.
Contact your Standard
Horizon dealer.