Filter
Top Products
Page 25HX750S
6.10 MEMORY SCAN
The HX750S can be programmed to scan channels from a minimum of 2 chan-
nels up to all channels in the marine band. If an incoming signal is detected on
one of the channels during scan, the radio will pause on that channel, allowing
you to listen to the incoming transmission.
1. Select the desired channel to be included in the scan memory using the
[
T
]
or
[
S
]
key.
2. Press the
[
MEM
]
key to store the channel into the
transceiver’s scan memory. “MEM” will be displayed on
the LCD.
3. Repeat steps 1 and 2 for all the channels to be scanned.
4. To delete a channel from the transceiver’s scan memory, select the memo-
rized channel, then press the
[
MEM
]
key until “MEM” is removed from the
display.
5. All channels programmed remain in the transceiver’s scan memory even if
the power is turned off.
6. Adjust the SQL level until background noise is eliminated by pressing the
[
SQL
]
key followed by the
[
T
]
/
[
S
]
key.
7. To start scanning, press the
[
SCAN
(
DW
)]
key. The scan proceeds from the
lowest to the highest programmed channel and stops scanning when a
transmission is received. Scanning will resume when the
incoming signal disappears at the end of the transmis-
sion. A blinking “SCN” icon will appears at the left bottom
of the display during scanning.
8. To stop the scan, press the
[
SCAN
(
DW
)]
key.