Filter
Top Products
PAGE 18 — SCT SERIES WALK-BEHIND TROWEL— PARTS & OPERATION MANUAL — REV. #4 (04/02/07)
3. Tighten cable clamp screw.
4. After the cable has been installed on the engine, work the
throttle lever to verify the throttle cable is at the proper
length. Adjust the cable as necessary.
5. Reinstall the air cleaner housing if previously removed.
SCT SERIES TROWEL — ASSEMBLY AND INSTALLATION
Assembly and Installation
Before the trowel can be put into operation there are some
components that must be installed before the trowel can be used.
This section provided general instructions on how to install those
components.
Handle Tube Installation
1. Install the
handle tube
to the gearbox as shown in (Figure 5).
The mounting hardware should be contained in the shipping
container.
Figure 5. Handle Tube Installation
2. Connect the throttle cable to the engine. (Figure 7). (The air
cleaner housing may have to be removed to provide access
for throttle cable installation.) When connecting the cable
housing, make sure that no more than
1/4" (6.4mm)
of the
cable housing protrudes past the housing clamp on the
engine.
Figure 7. Throttle Cable Connection
Figure 6. Throttle
Throttle Cable Installation
1. Set the
throttle
(Figure 6) to the idle position (lever away
from the operator).