Filter
Top Products
SCT SERIES WALK-BEHIND TROWEL — PARTS & OPERATION MANUAL — REV. #4 (04/02/07) — PAGE 23
NEVER disable or disconnect the centrifugal
safety stop switch. It is provided for the
operators’ safety and injury may result if it is
disabled, disconnected or improperly
maintained.
3. Place the
centrifugal safety stop switch
(Figure 19) in the
"ON" position.
Figure 19. Centrifugal Safety Stop Switch
4. Place the
Choke Lever
(Figure 20) in the "
CLOSED
"
position.
5. Grasp the starter grip (Figure 21) and slowly pull it out. The
resistance becomes the hardest at a position corresponding
to the compression point. Pull the starter grip briskly and
smoothly for starting.
Figure 21. Starter Grip
6. If the engine has started, slowly return the choke lever
(Figure 20) to the
"OPEN"
position. If the engine has not
started repeat steps 1 through 5.
7.
Before the trowel is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a loose guard ring and/or covers.
8. To begin troweling, move the throttle lever (Figure 22) toward
the "
RUN
" position by pulling back toward the operator..
Figure 22. Throttle (Run Position)
SCT SERIES TROWEL — INITIAL START-UP
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Figure 20. Engine Choke Lever