Filter
Top Products
Model 200EU-NOy Option Manual Addendum
1.0 Getting Started
The M501Y has been designed to operate with the M200EU low level NOx analyzer.
1.1 Unpacking
1. The M200EU with NOy Option comes in three boxes.
• The M200EU analyzer
• The Bypass Pump Chassis
• The External Converter and umbilical cable assembly
2. Verify that there is no apparent shipping damage. If damage has occurred please advise shipper
first, then API.
CAUTION
To avoid personal injury, always use two persons to lift and
carry the Model 501 Pump Pack Chassis.
3. Before operation of the M200EU, remove the shipping screws as shown in the M200E/EU Manual.
4. Please check the voltage and frequency label on the rear panel of the instrument for compatibility
with the local power before plugging in the M501Y.
1.2 Electrical and Pneumatic Connections
1. Mount the converter on a suitable mast outside of the enclosure.
2. Route the umbilical cable assembly into the shelter.
3. Locate the M200EU and M501Y Bypass Pump Chassis in close proximity, preferably mounting
one over the other in a 19” rack.
4. Connect the electrical/pneumatic cable fittings to the rear of the Bypass Pump Chassis. Use the
tags on each tube and Figure 1.1 to match up the correct tube with the rear panel bulkhead fitting.
Please note that the dashed lines show optional Zero/Span Valve configuration connections.
5. Connect the 7-pin power and signal cable to the connector on the rear of the Bypass Pump Chassis.
6. Connect the power cord to the correct line voltage.
WARNING
• Lethal voltages are present inside case
• Do not operate with cover off during normal operation
• Before operation, check for correct input voltage and frequency.
• Do not operate without proper chassis grounding
• Do not defeat the ground wire on power plug
• Turn off power before disconnecting electrical subassemblies
05386 Rev. A 7