Filter
Top Products
E-13
Uniden Atlantis 270 Radio Owner’s Manual
You can mount the charger on any at surface.
1. Use the two holes at the base of the charger
as a template to mark the drill holes.
2. Using a 1/8-inch (or 3 mm) drill bit,
drill two holes 1/2 inch (13mm) deep.
3. Use the provided screws to attach the
charger to the surface.
Your radio includes a charger and a
rechargeable battery pack. Place your radio
in the charger with the display facing forward.
Make sure that the CHARGE LED on the
charger turns orange.
x Use only the battery and charger supplied with
this radio. Using a different charger or battery can
damage the radio and create a risk of re or shock.
x The charger is not waterproof. If the charger falls into
the water, unplug it before attempting to remove it
from the water. After you remove the charger from the
water, please contact Customer Service (see the back
cover page for contact information).
x Wipe off dirt or shake water from your radio before
placing in the charger if your radio gets dirty or wet.
Important notes on charging the baery
x Charge the battery fully before using the radio. When the
battery is completely charged, the CHARGE LED turns
green.
x Don’t use the charger when the ambient temperature is
below 41° F (5° C) or above 104° F (40° C).
x If the radio is powered down, the battery can charge
in about seven hours. (If the radio is powered on, the