i. Turn the GPS105 ON.
ii. The Welcome display will appear.
iii. After 3 seconds the initial display will switch to the UHF-CB display.
iv. At the top of the display the unit will indicate it is searching for satellite information.
In this case an external GPS Antenna may be used in place of the internal antenna.
v. Turn OFF the unit and replace the GPS antenna if required and repeat steps i to iv.
vi. Secure all fittings.
For the initial power up it may take up to 15 minutes to secure satellite information.
When satellite data has been retrieved ' ' will disappear and
' ' will show at the top of the display.
SEARCHING FOR SATELLITE
GPS
If the unit continues to indicate searching for satellite beyond 15 minutes try holding
the GPS Internal Antenna outside of the vehicle. If satellite data is then retrieved and
' ' appears then the vehicle windscreen may have a tint which interferes with the
GPS signal. An optional External GPS Antenna may be fitted.
GPS
3
iv
Make sure the GPS antenna has an unobstructed view of the sky.
TEST FOR A GPS SIGNAL
SEARCHING FORSEARCHING FOR
INSTANT