E-10 Uniden MHS050-2 Owner’s Manual
Installing the battery pack incorrectly will prevent the unit from
operating.
CAUTION
Use only the supplied NiMH battery pack. Do not
charge alkaline or non rechargeable batteries.
5. Before placing the battery cover back on the radio, check the
rubber seal around the battery compartment and the ribbon of
the battery pack. Make sure that the seal is in good condition
and that there is no foreign matter under the seal.
If the rubber seal appears worn, nicked, or dried out, replace
it. Visit the website on the cover of this manual to order a
replacement seal.
6. Replace the battery compartment door. Tighten the screws
securely.
CHARGING THE BATTERY PACK
Your radio includes a charging cradle and a rechargeable battery
pack. Follow these instructions to recharge the radio in the
charging cradle.
NOTE
For the initial battery charge, make sure the radio is off
for optimum charging.
1. Connect the charging cradle to power. Refer to page 9.
2. Set the charging cradle on the desk or tabletop, and place the
radio in the charging cradle with the keypad facing forward.
3. Make sure that the LED illuminates. Charge the battery pack for
13 hours then remove the radio from the charging cradle.