2
DO NOT BEGIN INSTALLATION UNTIL YOU READ
THE FOLLOWING PRECAUTIONS.
PRECAUTIONS
1. Failure to turn off electric or main gas supply
to heating system could cause personal in-
jury and/or property damage by shock, gas
suffocation, fire, and/or explosion.
2. Do not use this control on circuits exceeding
specified voltage. Higher voltage will damage
the control and may cause shock or fire
hazard.
3. NEVER USE FLAME OR ANY KIND OF SPARK
TO CHECK FOR GAS LEAKS–COULD CAUSE
FIRE AND/OR EXPLOSION.
4. DO NOT USE WIRE JUMPER on pilot sys-
tems, such as standing pilot, proven pilot, or
spark-to-pilot ignition–a fire and/or explosion
may result.
5. Do not use a control set for natural gas with
LP gas, or a control set for LP gas with natural
gas. Personal injury and/or property damage,
gas suffocation, fire, and/or explosion may
result.
1. Do not short out terminals on gas valve or
primary control to test. Short or incorrect
wiring can cause equipment damage, prop-
erty damage, and/or personal injury.
2. This control is not intended for use in loca-
tions where it may come in direct contact with
water. Suitable protection must be provided
to shield the control from exposure to water
(dripping, spraying, rain, etc.).
WARNING
!
If you do not follow these instructions exactly, a fire or explosion may
result, causing property damage, personal injury or loss of life.
CAUTION
!