Filter
Top Products
2-23
FEATURES & FUNCTIONS 2
4. Still supporting the upper section of
the wakeboard tower, install the two
short supports
④
using two screw
knobs on each side. Install the teth-
ered rings ⑤ into the ends of the
upper tower support screw knobs
to prevent them from loosening or
coming out during operation.
5. Carefully store the remaining screw
knobs and the tower supports in a
storage compartment in the boat.
Raising
1. Support the tower and attach the
tower supports on both sides, leav-
ing the screw knobs slightly loose.
2. While the assistant is pushing the
upper tower section upward slightly,
carefully thread the screw knobs
into the forward pivot points into the
tower base.
3. Once all of the knobs are threaded
in, make sure each one is tight-
ened securely. Install the tethered
rings into the ends of the upper
tower support screw knobs to pre-
vent them from loosening or com-
ing out during operation. NOTICE:
Be sure to use the tethered rings
to secure the upper tower sup-
port knobs. Otherwise the knobs
could loosen and be lost if they
fall out.
11 12 13 14 15 16 17 18 19 20
21 22 23 24 25 26 27 28 29 30
31 32 33 34 35 36 37 38 39 40
41 42 43 44 45 46 47 48 49 50
51 52 53 54 55 56 57 58 59 60
1 2 3 4 5 6 7 8 9 10
11 12 13 14 15 16 17 18 19 20
21 22 23 24 25 26 27 28 29 30
31 32 33 34 35 36 37 38 39 40
41 42 43 44 45 46 47 48 49 50
51 52 53 54 55 56 57 58 59 60
1 2 3 4 5 6 7 8 9 10
11 12 13 14 15 16 17 18 19 20
21 22 23 24 25 26 27 28 29 30
31 32 33 34 35 36 37 38 39 40
41 42 43 44 45 46 47 48 49 50
51 52 53 54 55 56 57 58 59 60
1 2 3 4 5 6 7 8 9 10