Filter
Top Products
Operation
22
2. Replace the fuel can cap and close tight-
ly.
3. Shake the fuel can to mix the fuel thor-
oughly.
4. Make sure that the oil and gasoline are
mixed.
5. Pour the gasoline and oil mixture into the
built-in fuel tank.
CAUTION:
ECM00810
●
Avoid using any oil other than the spec-
ified type.
●
Use a thoroughly blended fuel-oil mix-
ture.
●
If the mixture is not thoroughly mixed,
or if the mixing ratio is incorrect, the
following problems could occur. Low
oil ratio: Lack of oil could cause major
engine trouble, such as piston seizure.
●
High oil ratio: Too much oil could cause
fouled spark plugs, smoky exhaust,
and heavy carbon deposits.
NOTE:
If using a permanently installed tank, pour
the oil gradually as the gasoline is being add-
ed to the tank.
EMU27450
Operating engine
EMU27461
Feeding fuel (portable tank)
WARNING
EWM00420
●
Before starting the engine, make sure
that the boat is tightly moored and that
you can steer clear of any obstructions.
Be sure there are no swimmers in the
water near you.
●
When the air vent screw is loosened,
gasoline vapor will be released. Gaso-
line is highly flammable, and its vapors
are flammable and explosive. Refrain
from smoking, and keep away from
open flames and sparks while loosen-
ing the air vent screw.
●
This product emits exhaust gases
which contain carbon monoxide, a col-
orless, odorless gas which could cause
brain damage or death when inhaled.
Symptoms include nausea, dizziness,
and drowsiness. Keep cockpit and cab-
in areas well ventilated. Avoid blocking
exhaust outlets.
1. If there is an air vent screw on the fuel
tank cap, loosen it 2 or 3 turns.
2. If there is a fuel joint on the motor, firmly
connect the fuel line to the joint. Then
firmly connect the other end of the fuel
line to the joint on the fuel tank.
ZMU02022
ZMU04113