Filter
Top Products
5
Initialization
Initializing trim angle
4. Use the directional keypad to select
the sensor from the “Sensor” list.
5. Set using the “SET” button.
1. Fully trim the outboard motor down.
2. Use the directional keypad and the
“SET” button to display the “Trim
Level” in the menu screen.
3. Check that the value displayed on the
screen shows “0 %.”
4. Use the “SET” button to reset the value
if any value other than “0 %” is dis-
played.
SET
MENU
CANCEL
SET
MENU
CANCEL
SET
MENU
CANCEL
SET
MENU
CANCEL
6Y9_US_E0.fm Page 5 Tuesday, March 23, 2010 2:17 PM