Filter
Top Products
Maintenance and care
69
water passages by alternately squeezing
and releasing the throttle lever for 10 to
15 seconds.
(8) Stop the engine.
(9) Remove the garden hose adapter and in-
stall the flushing hose connector cap.
EJU33610
Lubrication
WARNING
EWJ00260
Do not spray flammable rust inhibitor
products on engine surfaces while the en-
gine is hot. The sprayed substance or pro-
pellants could catch fire.
(1) Remove the seat. (See page 28 for seat
removal and installation procedures.)
(2) Loosen the clamp screw and disconnect
the air intake duct.
(3) Spray a rust inhibitor such as Yamaha
Stor-Rite Engine Fogging Oil into the in-
take opening for 3 seconds.
(4) Connect the air intake duct and tighten
the clamp screw.
(5) Start the engine in a well-ventilated area
and let it run at idle for 15 seconds.
CAUTION:
ECJ00160
Do not run the engine for more than 15
seconds, otherwise the engine could over-
heat.
(6) Lubricate all cables such as the throttle
and steering cables.
NOTE:
Use a Yamaha Power Cable Luber and
Yamaha Lube-Zall to pressure-lubricate the
cables and purge out any moisture between
the inner and outer cables.
(7) Lubricate the areas of the watercraft
specified in “Lubrication points” on page
78.
EJU33660
Fuel system
WARNING
EWJ00280
GASOLINE AND ITS VAPORS ARE HIGH-
LY FLAMMABLE AND EXPLOSIVE!
1 Clamp screw
2 Air intake duct
1 Intake opening
UF1K12E0.book Page 69 Friday, July 28, 2006 10:35 AM